Oil Sands Hydraulic Shovels Mining

oil sands hydraulic shovels mining - ellul.nl

new design hydraulic sand mining machine. However, hydraulic shovels are less reliable since the oil used to control content of silica sand, which wears away at the metal frame of the haul truck.

Oil Sands Mining Equipment Built Tough | MINING

The overburden is used to build haul roads and tailings dikes, while the oil sands, thick and heavy with tarry bitumen, are piled high in long benches using hydraulic or electric rope shovels ...

Evolution of Mining Equipment in the Oil Sands | Oil Sands ...

The norm in oil sands is 4 passes - i.e., 4 shovel loads are required to fill a dump truck. This is normally completed in less than 2 minutes! ELECTRIC SHOVELS. Electric rope and pulley shovels are the workhorse of oil sands mining. Electric shovels are reliable and relatively low cost to operate. However, electric shovels are tethered to a ...

Worlds Largest Hydraulic Shovel, The O&K RH 400 Loads CAT ...

Aug 19, 2011 · Video from the oil sand mines of northern Alberta, Canada. The shovel is loading over burdon at around 70 to 90 ton each pass. The 797 has a 400 ton pay load.

Oil Sands - Canadian Association of Petroleum Producers

About 20 per cent of the oil sands reserves are located close enough to the surface to be mined using large shovels and trucks. New technology and innovation are critical to developing the oil sands and improving environmental performance. Oil sands operators must adhere to stringent regulations.

Mining for Bitumen | Oil Sands Magazine

OIL SANDS MINING PIT. Typically a truck-and-shovel operation, oil sands is excavated from the mine pit using hydraulic or electric shovels. A typical shovel load of is about 90 tonnes. Mined oil sands normally contains from 7 to 13% bitumen by weight.

Equipment - KMC Mining

These applications in the mining industry put hard demands on hydraulic excavators and it takes sturdy equipment to stand up to the challenge. KMC has played an important role in the development of the ultra size shovels, through joint development between KMC and Demag/Komatsu in Germany.

Tar Sands Basics - Argonne National Laboratory

New methods introduced in the 1990s considerably improved the efficiency of tar sands mining, thus reducing the cost. These systems use large hydraulic and electrically powered shovels to dig up tar sands and load them into enormous trucks that can carry up to 320 tons of tar sands per load.

oil sands hydraulic shovels mining - manveesingh

Athabasca oil sands - Wikipedia. The Athabasca oil sands (or tar sands) are large deposits of bitumen or extremely heavy crude oil, located in northeastern Alberta, Canada – roughly centred on the boomtown of Fort McMurray. Get A Quote

Fourth quarter surge in shipments of large mining equipment

These data are the result of direct reporting of individual machines shipped by the leading manufacturers of large mining trucks, electric/rope and hydraulic shovels/excavators, wheel loaders ...

About Oil Sands - energy.alberta.ca

Surface mining is used to recover oil sands deposits less than 75 meters below the surface, while in-situ technologies are used to recover deeper deposits. The electric and hydraulic shovels used have a capacity of 45 m3 and trucks can carry up to 400 tons of ore.

Oil Sands - Wajax

The unique conditions in oil sands operations require unique solutions, and Wajax has the products and expertise to support you from start to finish. Whether you’re extracting oil sands via an open pit mine or in-situ thermal process, our solution-based approach will address the challenges your operation is facing safely and sustainably.

Bigger Shovels Coming for Mining - WSJ

Budgets at above-ground mining companies may be shrinking as demand for commodities cools, but their suppliers keep touting bigger and pricier shovels able to fill giant trucks with fewer scoops.

oil sands crusher - ellul.nl

oil sands hydraulic shovels mining - crusherasia. oil sands hydraulic shovels mining. Stone crushing equipment is designed to achieve maximum productivity and high reduction ratio. From large primary jaw crusher and impact crusher to cone crusher … Get Price

Athabasca Oil Sands Project, Canada - Mining Technology ...

Map showing the extent of the Athabasca Oil Sands. Oil sand bitumen is a mixture of sand, water and clay. Located around Fort McMurray in the north of Alberta, Canada, the Athabasca Oil Sands – named after the river that cuts through the heart of the deposit – is the largest of province’s three oil sands …

oil sands hydraulic shovels mining - ascgu

oil sands hydraulic shovels mining - … Oil sands - Wikipedia. Bitumen has been found adhering to stone tools used, With the increasing use of hydraulic fracturing making, A large part of oil sands mining ...

Tar Sands | Energy and Security - The Strauss Center

Though concentrated in North America, the production of oil from tar sands has broad implications for the global oil market.Tar sands, which are also known as oil sands, are a combination of clay, sand, water and bitumen (a heavier form of oil).

Oil Sands Mining | Student Energy

Oil Sands Mining. Definition. Oil sands are a mixture of sand, water, clay and bitumen found in several locations around the globe, with the largest reserve located in Alberta, Canada. Oil sand can be upgraded into synthetic crude oil and other petroleum products Alberta Energy. What is Oil Sands…

As big as it gets | Hydraulics & Pneumatics

In other words, it can fill up even the largest mining trucks with 3-5 passes! In the Canadian tar sands — regarded as one of the toughest mining applications known — the RH400 has achieved a new production world record for hydraulic shovels: more than 9900 t/hr during performance testing and more than 6050 t/hr on average.

Athabasca oil sands - Wikipedia

In mid-2006, the National Energy Board of Canada estimated the operating cost of a new mining operation in the Athabasca oil sands to be C$9 to C$12 per barrel, while the cost of an in-situ SAGD operation (using dual horizontal wells) would be C$10 to C$14 per barrel.

Equipment and geology related causes of oil sands lumps ...

other operators in the growing number of mines excavating Athabasca oil sands. 2. Problems caused by large oil sands lumps Frozen oil sands lumps are created at the face by hydraulic and cable-electric shovels excavating material in the winter months. When the shovel operator identifies a …

oil sands hydraulic shovels mining

A variety of mining equipment is used in the mining of oil sands by surface mining This includes bucket wheel excavators, draglines, hydraulic shovels and off-highway trucks This paper examines the existing mining schemes and equipment used Peculiarities of oil ,

Oil Sands Mining - aer.ca

In surface mining, companies use trucks and shovels to scoop up oil sands from the ground. The oil sands are then transported to extraction plants, where bitumen (heavy oil) is separated from the sand.

Dealing with High Pressure in the Canadian Oil Sands ...

An interview with John Owens, Supervisor – Hydraulic Hose Technician at North American Construction Group Based in Acheson, an industrial hub in the Greater Edmonton area of Alberta, Canada, John Owens supervises the assembly of hydraulic hoses for North American Construction Group (NACG), a leading provider of heavy construction and mining services in Canada.

The world’s biggest mining excavators - Mining Technology

With an operating weight of 744t, the Demag H740 OS excavator is the fourth biggest mining excavator. It has been in service since 1999 and was specially designed for the abrasive oil sands works of KMC Mining in Canada. The Demag H740 OS is a front-shovel excavator with a wider car body and trackpad than its predecessors.

Shovels and trucks pair for efficient loading and hauling ...

When volume is the key to profitability, pairing loaders and haulers can be important. Cat offers a solution for large volume mining and oil sands operations that offers a complete solution from pile to processing. For moving plenty of volume efficiently, the Cat 7495 electric rope shovel is a good choice.

Tar Sands Facts | | Indigenous Environmental Network

Removing the Tar Sands – Strip Mining Process. It takes approximately two tons of tar sands along with another two tones of overburden (containing soil, sand, clay and rock) to yield one barrel of oil. Hydraulic shovels are used to tear into the earth and were exculsively manufactured for this purpose – they are the largest in the world.

bucyrus mining shovels-Roadheader For Sales-our company

The Biggest, Baddest Shovels in the World - Popular Mechanics. From mining the oil sands of Alberta to boring under the English Channel, some of the most …

Cat 6020B Hydraulic Mining Shovel - heavyequipmentguide.ca

The Cat 6020B Hydraulic Mining Shovel is a brand new model in the extensive line of Cat hydraulic mining shovels. The clean-sheet design features a 22-tonne (24-ton) payload and 224-tonne (247-ton) operating weight and teams with the Cat 777G Off-Highway Truck for optimized loading and hauling.

Specalog for 6090 FS Hydraulic Shovel AEHQ7094-00

as needed, whether the engine is idling or under load. That means optimum oil temperature is being maintained, even while your operator waits for the next truck to load. Competitive hydraulic mining shovels only provide cooling when the machine is working and the engine is under load.

The Biggest, Baddest Shovels in the World - Popular Mechanics

From mining the oil sands of Alberta to boring under the English Channel, some of the most extreme machines made by man are devoted to digging.

Hybrid shovels - Surface mining - Australia | Komatsu ...

Oil sands Background information ... Engineered to blend the high productivity of electric mining shovels with the mobility and flexibility of diesel hydraulic excavators, the 2650CX features an articulating hydraulic clamshell attachment to deliver a 65-ton payload, performing four-pass loads of 240-ton trucks with the capability of also ...

Cat | 6090 FS Hydraulic Shovel | Caterpillar

You will experience safer, easier and faster front shovel operation with TriPower, a system proven on over a thousand Cat hydraulic mining shovels worldwide. Generating superior mechanical leverage and control, our FS configured hydraulic mining shovels utilize a unique boom design that employs rotatable triangular rockers.

The Future of oil sands - globaloilsands

Mining oil sands is currently undertaken only in open cut operations The oil sands are excavated by mobile shovels and moved by huge trucks or slurry pipelines to extraction facilities where the oil is recovered often by mixing the sands with warm water and chemicals like caustic soda and solvents.

Equipment and geology related causes of oil sands lumps ...

Hydraulic shovels were found to generate more loads delivered to a lump dump than cable-electric shovels on a normalized basis. Methods to minimize the occurrence and effects of frozen lumps and ways to improve overall mining efficiency during the winter months are suggested.

Fracking and Tar Sands - selfgrowth

The oil sands can be extracted using open mining at the surface. New methods of the 1990's improved the efficiency of the mining which reduces the cost. The systems use large hydraulic and electrically powered shovels to dig the sands up and load them into gigantic dump trucks.

Oil Sands - Investopedia

Oil sands, or tar sands, are sand and rock material which contains crude bitumen, a dense, viscous form of crude oil.Bitumen is too thick to flow on its own, so extraction methods are necessary.

Oil sands - SEG Wiki

Surface mining. About 20 percent of the world’s oil sands are located close to the surface. In surface mining, large hydraulic and electrically powered shovels are used to dig up oil sands from the ground and load them into trucks.